1.關于 EDIMAX EW-7822UAC

官網介紹
https://www.edimax.com/edimax/merchandise/merchandise_detail/data/edimax/global/wireless_adapters_ac1200_dual-band/ew-7822uac/

詳細參數：https://www.amazon.cn/dp/B00F97PU18

• 品牌：EDiMAX
• 制造商：?Edimax
• 型號 ?FBA_EW-7822UAC
• 芯片：Realtek RTL8812AU
• 商品尺寸 ?20.29 x 13.49 x 3.81 cm
• 制造商是否已停產 ?不是
• 顏色 ?黑色//白色
• 計算機無線類型：?802.11bgn
• 操作系統：Windows 8; Mac OS X (10.8.4 or above supports USB 3.0)
• 是否包含電池：?不是
• 商品重量：?118 g

2.驅動安裝

這里以 Xubuntu16.04系統（內核：4.14）為例

• 下載地址：https://download.csdn.net/download/qq_45445740/88614252
• 下載后拷貝到目標設備上進行解壓，運行 install-driver.sh 腳本

sudo ./install-driver.sh

• 待install-driver.sh安裝完后可選擇N，修改如下文件，將 /etc/modprobe.d/8812au.conf前面的 #號 去掉，保存。
  
  
• 重啟設備

3.查看無線網卡信息

• 此時可查看到插入的無線網卡信息

ifconfig

• 這里以 wlx08beac134a56 為例，查看可選擇的信道

iwlist wlx08beac134a56 channel

• 查看無線網卡的詳細信息

iw list

root@aubo-1712986093:~# iw list
Wiphy phy1max # scan SSIDs: 9max scan IEs length: 2304 bytesRetry short limit: 7Retry long limit: 4Coverage class: 0 (up to 0m)Supported Ciphers:* WEP40 (00-0f-ac:1)* WEP104 (00-0f-ac:5)* TKIP (00-0f-ac:2)* CCMP (00-0f-ac:4)* CMAC (00-0f-ac:6)Available Antennas: TX 0 RX 0Supported interface modes:* IBSS* managed* AP* monitor* P2P-client* P2P-GOBand 1:Capabilities: 0x1962HT20/HT40Static SM Power SaveRX HT20 SGIRX HT40 SGIRX STBC 1-streamMax AMSDU length: 7935 bytesDSSS/CCK HT40Maximum RX AMPDU length 65535 bytes (exponent: 0x003)Minimum RX AMPDU time spacing: 16 usec (0x07)HT TX/RX MCS rate indexes supported: 0-15Bitrates (non-HT):* 1.0 Mbps* 2.0 Mbps* 5.5 Mbps* 11.0 Mbps* 6.0 Mbps* 9.0 Mbps* 12.0 Mbps* 18.0 Mbps* 24.0 Mbps* 36.0 Mbps* 48.0 Mbps* 54.0 MbpsFrequencies:* 2412 MHz [1] (17.0 dBm)* 2417 MHz [2] (17.0 dBm)* 2422 MHz [3] (17.0 dBm)* 2427 MHz [4] (17.0 dBm)* 2432 MHz [5] (17.0 dBm)* 2437 MHz [6] (17.0 dBm)* 2442 MHz [7] (17.0 dBm)* 2447 MHz [8] (17.0 dBm)* 2452 MHz [9] (17.0 dBm)* 2457 MHz [10] (17.0 dBm)* 2462 MHz [11] (17.0 dBm)* 2467 MHz [12] (disabled)* 2472 MHz [13] (disabled)* 2484 MHz [14] (disabled)Band 2:Capabilities: 0x862HT20/HT40Static SM Power SaveRX HT20 SGIRX HT40 SGINo RX STBCMax AMSDU length: 7935 bytesNo DSSS/CCK HT40Maximum RX AMPDU length 65535 bytes (exponent: 0x003)Minimum RX AMPDU time spacing: 16 usec (0x07)HT TX/RX MCS rate indexes supported: 0-15VHT Capabilities (0x03c031a2):Max MPDU length: 11454Supported Channel Width: neither 160 nor 80+80short GI (80 MHz)TX STBCSU Beamformee+HTC-VHTVHT RX MCS set:1 streams: MCS 0-92 streams: MCS 0-93 streams: not supported4 streams: not supported5 streams: not supported6 streams: not supported7 streams: not supported8 streams: not supportedVHT RX highest supported: 867 MbpsVHT TX MCS set:1 streams: MCS 0-92 streams: MCS 0-93 streams: not supported4 streams: not supported5 streams: not supported6 streams: not supported7 streams: not supported8 streams: not supportedVHT TX highest supported: 867 MbpsBitrates (non-HT):* 6.0 Mbps* 9.0 Mbps* 12.0 Mbps* 18.0 Mbps* 24.0 Mbps* 36.0 Mbps* 48.0 Mbps* 54.0 MbpsFrequencies:* 5180 MHz [36] (16.0 dBm)* 5200 MHz [40] (16.0 dBm)* 5220 MHz [44] (16.0 dBm)* 5240 MHz [48] (16.0 dBm)* 5260 MHz [52] (disabled)* 5280 MHz [56] (disabled)* 5300 MHz [60] (disabled)* 5320 MHz [64] (disabled)* 5500 MHz [100] (disabled)* 5520 MHz [104] (disabled)* 5540 MHz [108] (disabled)* 5560 MHz [112] (disabled)* 5580 MHz [116] (disabled)* 5600 MHz [120] (disabled)* 5620 MHz [124] (disabled)* 5640 MHz [128] (disabled)* 5660 MHz [132] (disabled)* 5680 MHz [136] (disabled)* 5700 MHz [140] (disabled)* 5720 MHz [144] (disabled)* 5745 MHz [149] (16.0 dBm)* 5765 MHz [153] (16.0 dBm)* 5785 MHz [157] (16.0 dBm)* 5805 MHz [161] (16.0 dBm)* 5825 MHz [165] (16.0 dBm)* 5845 MHz [169] (disabled)* 5865 MHz [173] (disabled)* 5885 MHz [177] (disabled)Supported commands:* new_interface* set_interface* new_key* start_ap* new_station* set_bss* join_ibss* set_pmksa* del_pmksa* flush_pmksa* remain_on_channel* frame* set_channel* connect* disconnectSupported TX frame types:* IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0* P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0Supported RX frame types:* IBSS: 0xd0* managed: 0x40 0xb0 0xd0* AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0* AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0* P2P-client: 0x40 0xd0* P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0WoWLAN support:* wake up on anything (device continues operating normally)software interface modes (can always be added):* monitorinterface combinations are not supportedDevice supports SAE with AUTHENTICATE commandDevice supports scan flush.

3.通過create_ap配置5G自發AP

下載配置create_ap

• 這里以165信道為例

CHANNEL=165
GATEWAY=10.0.0.1
WPA_VERSION=2
ETC_HOSTS=0
DHCP_DNS=gateway
NO_DNS=0
NO_DNSMASQ=0
HIDDEN=0
MAC_FILTER=0
MAC_FILTER_ACCEPT=/etc/hostapd/hostapd.accept
ISOLATE_CLIENTS=0
SHARE_METHOD=nat
IEEE80211N=0
IEEE80211AC=0
HT_CAPAB=[HT40+]
VHT_CAPAB=
DRIVER=nl80211
NO_VIRT=0
COUNTRY=CN
FREQ_BAND=2.4
NEW_MACADDR=
DAEMONIZE=0
NO_HAVEGED=0
WIFI_IFACE=wlx08beac134a56
INTERNET_IFACE=enp1s0
SSID=USB-IS-Test
PASSPHRASE=12345678
USE_PSK=0

• 開啟后可通過Cellular-Z軟件查看是否真正開啟了5G信道