ipad iphone開發

If your iDevice starts acting strangely and you’ve run through the gamut of normal troubleshooting fixes, Recovery Mode may be your answer. This lets you easily reset the device and re-install iOS using iTunes.

如果您的iDevice開始運行異常，并且已經完成了正常的故障排除修補程序，那么恢復模式可能是您的答案。 這使您可以輕松地重置設備并使用iTunes重新安裝iOS。

When you reinstall iOS, there’s a chance that you may lose all the data on your phone, so it’s good to stay in the habit of making regular backups on your computer via iTunes or iCloud. With that said, here’s how you can boot your iOS device into Recovery Mode.

重新安裝iOS時，您可能會丟失手機上的所有數據，因此，最好養成通過iTunes或iCloud在計算機上進行定期備份的習慣。 話雖如此，這是將iOS設備引導到恢復模式的方法。

首先，請確保您擁有最新的iTunes版本 (First, Make Sure You Have the Latest iTunes Version)

First, you’ll need to make sure you’re using the latest version of iTunes. With the program open, head to iTunes > About iTunes.

首先，您需要確保使用的是最新版本的iTunes。 打開程序后，轉到iTunes>關于iTunes。

Make a note of the version you’re using, and check it against this official Apple Support page to see if you’re on the newest release.

記下您正在使用的版本，然后在此Apple支持頁面上進行檢查，以查看您是否在最新版本中。

With that out of the way, you’re ready to get started. The rest of the procedure varies slightly depending on what device you’re using, so we’ll go over them one at a time.

有了這些，您就可以開始了。 其余的過程會根據您使用的設備而略有不同，因此我們將一次對其進行遍歷。

對于iPhone 7 / iPhone 7 Plus或更高版本 (For iPhone 7/iPhone 7 Plus or Later)

If you’re using an iPhone 7, 7 Plus, 8, 8 Plus, X, XS, XS Max, or XR, here’s what to do.

如果您使用的是iPhone 7、7 Plus，8、8 Plus，X，XS，XS Max或XR，請執行以下操作。

First, make sure your phone is off. Then, press and?release the volume up button.

首先，請確保手機已關機。 然后，按下并釋放音量增大按鈕。

Next, immediately press and release the volume down button.

接下來，立即按下并釋放降低音量按鈕。

Now, hold the side button, the only one on the side opposite the volume buttons. Don’t let go of the button even when the Apple logo flashes onscreen. Continue to hold until the Recovery Mode screen appears.

現在，按住側面按鈕，音量按鈕對面的唯一一個按鈕。 即使Apple徽標在屏幕上閃爍，也不要放開按鈕。 繼續按住直到出現“恢復模式”屏幕。

Once that screen appears, go ahead and connect your device to your computer via Lightning Cable.

出現該屏幕后，繼續進行操作，然后通過Lightning Cable將設備連接到計算機。

對于iPhone 6s或更早版本和大多數iPad (For the iPhone 6s or Earlier and Most iPads)

These instructions cover the iPhone 6s and earlier models, as well as most iPad models other than the iPad Pro 11- and 12.9-inch. For those two, check out the next section.

這些說明適用于iPhone 6s和更早的型號，以及除iPad Pro 11英寸和12.9英寸以外的大多數iPad型號。 對于這兩個，請查看下一部分。

First, make sure your device is powered off. Then, press and?release the volume up button.

首先，請確保設備已關閉電源。 然后，按下并釋放音量增大按鈕。

Next, press and hold the Home and the Sleep/Wake buttons. The Sleep/Wake button is on the side for iPhone 6 or later users, and on the top right for iPhone 5s and earlier. Don’t let go of the buttons, even when the Apple logo flashes onscreen. Continue to hold until the Recovery Mode screen appears.

接下來，按住主屏幕和“睡眠/喚醒”按鈕。 對于iPhone 6或更高版本的用戶，“睡眠/喚醒”按鈕在側面；對于iPhone 5s和更低版本的用戶，在右上方。 即使Apple徽標在屏幕上閃爍，也不要松開按鈕。 繼續按住直到出現“恢復模式”屏幕。

Once that appears, go ahead and connect the device to your computer.

出現之后，繼續并將設備連接到計算機。

適用于11英寸iPad Pro或12.9英寸iPad Pro (For iPad Pro 11-inch or iPad Pro 12.9-inch)

Press and quickly release the Volume Up button, then press and quickly release the Volume Down button. Press and hold the Sleep/Wake button at the top of the device until it restarts. Keep holding the Sleep/Wake button until the iPad goes into Recovery mode.

按下并快速釋放音量調高按鈕，然后按下并快速釋放音量調低按鈕。 按住設備頂部的“睡眠/喚醒”按鈕，直到重新啟動。 按住“睡眠/喚醒”按鈕，直到iPad進入恢復模式。

When Recovery Mode launches, connect the device to your computer.

啟動恢復模式后，將設備連接到計算機。

進入恢復模式后該怎么辦 (What to Do Once You’re in Recovery Mode)

Now that your device is in Recovery Mode, you have about 15 minutes before it automatically exits. If you don’t move quickly enough and your phone exits Recovery Mode, repeat the same button presses as explained above to enter it again.

現在您的設備處于恢復模式，您大約需要15分鐘才能自動退出。 如果移動速度不夠快，并且手機退出了恢復模式，請按如上所述的相同操作重復按該按鈕以再次輸入。

A window like the one below will pop up on your computer once you’ve successfully entered Recovery Mode on your phone or tablet. When you see the options “Restore or Update,” choose Update.

在手機或平板電腦上成功進入恢復模式后，計算機上將彈出如下所示的窗口。 當您看到“還原或更新”選項時，選擇“更新”。

You will want to try “Update” instead of “Restore” because your issues may very well be fixed through a simple update to your iPhone, which will keep all of your content and personal settings. If this does not work, however, you might have to choose the “Restore” option, which will erase all of your content and personal data on your device. Don’t accidentally click “Restore” if you don’t have a viable backup of your data or want to go through with that process and make sure you try “Update” first to save yourself some potential heartache.

您將要嘗試“更新”而不是“還原”，因為通過對iPhone進行簡單更新就可以很好地解決您的問題，該更新將保留您所有的內容和個人設置。 但是，如果這不起作用，則可能必須選擇“還原”選項，這將清除設備上的所有內容和個人數據。 如果您沒有可行的數據備份，或者想要執行該過程并確保先嘗試執行“更新”以免自己遭受潛在的痛苦，請不要無意間單擊“還原”。

Choose “Update,” then, and iTunes will work to reinstall iOS on your phone while leaving your data intact. When the Update or Restore process has been completed, you’ll be prompted to set up your device.

選擇“更新”，然后iTunes將繼續在您的手機上重新安裝iOS，同時保持數據不變。 更新或還原過程完成后，系統將提示您設置設備。

翻譯自: https://www.howtogeek.com/396530/how-to-put-your-iphone-or-ipad-into-recovery-mode/

ipad iphone開發