1.1 適配mipi屏幕觸摸

gt9xx_lvds: gt9xx-lvds@5d {compatible = "goodix,gt9xx";reg = <0x5d>;pinctrl-names = "default";pinctrl-0 = <&touch_gpio>;touch-gpio = <&gpio1 RK_PA4 IRQ_TYPE_LEVEL_LOW>;reset-gpio = <&gpio1 RK_PB0 GPIO_ACTIVE_HIGH>;max-x = <1280>;max-y = <800>;tp-size = <970>;status = "okay";};

1.2 觸摸常見問題

觸摸有報點但是沒有觸摸到屏幕邊緣，但鼠標指針已經到了屏幕邊緣。對調以下參數。
touchscreen-size-x = <800>;
touchscreen-size-y = <1280>;

2.1 初始化序列命令介紹

舉例：13 00 02 01 00
說明：數據類型 延時 數據個數(包含寄存器)  寄存器 寄存器數據
舉例：39 00 04 FF 98 81 03
說明：數據類型 延時 數據個數(包含寄存器)  寄存器 寄存器數據  寄存器數據 寄存器數據
//初始化序列常見數據類型：Generic Write0x03：沒有寄存器數據0x13：1個寄存器數據0x23：2個寄存器數據0x29：多個寄存器數據
//初始化序列常見數據類型：DCS Write0x05：沒有寄存器數據0x15：1個寄存器數據0x07：1個寄存器數據,DSC EN0x0a：DCS long WRITE, PPS, 128 bytes0x39：多個寄存器數據

2.2 適配mipi屏幕顯示

dsi0_backlight: dsi0-backlight {compatible = "pwm-backlight";pwms = <&pwm3 0 20000 0>;brightness-levels = <0  20  20  21  21  22  22  2323  24  24  25  25  26  26  2727  28  28  29  29  30  30  3131  32  32  33  33  34  34  3535  36  36  37  37  38  38  3940  41  42  43  44  45  46  4748  49  50  51  52  53  54  5556  57  58  59  60  61  62  6364  65  66  67  68  69  70  7172  73  74  75  76  77  78  7980  81  82  83  84  85  86  8788  89  90  91  92  93  94  9596  97  98  99 100 101 102 103104 105 106 107 108 109 110 111112 113 114 115 116 117 118 119120 121 122 123 124 125 126 127128 129 130 131 132 133 134 135136 137 138 139 140 141 142 143144 145 146 147 148 149 150 151152 153 154 155 156 157 158 159160 161 162 163 164 165 166 167168 169 170 171 172 173 174 175176 177 178 179 180 181 182 183184 185 186 187 188 189 190 191192 193 194 195 196 197 198 199200 201 202 203 204 205 206 207208 209 210 211 212 213 214 215216 217 218 219 220 221 222 223224 225 226 227 228 229 230 231232 233 234 235 236 237 238 239240 241 242 243 244 245 246 247248 249 250 251 252 253 254 255>;default-brightness-level = <200>;
};&dsi0 {status = "okay";//rockchip,lane-rate = <1000>;dsi0_panel: panel@0 {status = "okay";compatible = "simple-panel-dsi";reg = <0>;reset-delay-ms = <60>;enable-delay-ms = <60>;prepare-delay-ms = <60>;unprepare-delay-ms = <60>;disable-delay-ms = <60>;dsi,flags = <(MIPI_DSI_MODE_VIDEO | MIPI_DSI_MODE_VIDEO_BURST |MIPI_DSI_MODE_LPM | MIPI_DSI_MODE_EOT_PACKET)>;dsi,format = <MIPI_DSI_FMT_RGB888>;dsi,lanes  = <4>;panel-init-sequence = [         ];panel-exit-sequence = [];panel-width-mm = <68>;panel-height-mm = <121>;backlight = <&dsi0_backlight>;enable-gpios = <&gpio0 RK_PC7 GPIO_ACTIVE_HIGH>;display-timings {native-mode = <&panel10_1280x800>;panel10_1280x800: timings {hback-porch     = <40>;hfront-porch    = <40>;hactive         = <800>;hsync-len       = <20>;vback-porch     = <20>;vfront-porch    = <20>;vactive         = <1280>;vsync-len       = <10>;clock-frequency = <72000000>;vsync-active    = <0>;hsync-active    = <0>;de-active       = <0>;pixelclk-active = <0>;};};ports {#address-cells = <1>;#size-cells = <0>;port@0 {reg = <0>;panel_in_dsi0: endpoint {remote-endpoint = <&dsi0_out_panel>;};};};};ports {#address-cells = <1>;#size-cells = <0>;port@1 {reg = <1>;dsi0_out_panel: endpoint {remote-endpoint = <&panel_in_dsi0>;};};};
};//開啟uboot和內核logo
&route_dsi0 {status = "okay";connect = <&vp0_out_dsi0>;
};&dsi0_in_vp0 {status = "okay";
};&dsi0_in_vp1 {status = "disabled";
};&pwm3 {status = "okay";

};